9-4 ELECTRICAL SYSTEM SEMI-CONDUCTOR EQUIPPED PART • Be careful not to drop the part with a semi-conductor built in INCORRECT such as a ECM. • When inspecting this part, follow inspection instruction strictly. Neglecting proper procedure may cause damage to this part. BATTERY • The MF battery used in this motorcycle does not require main- tenance (e.g., electrolyte level inspection, distilled water replenishment). • During normal charging, no hydrogen gas is produced. How- ever, if the battery is overcharged, hydrogen gas may be pro- duced. Therefore, be sure there are no fire or spark sources (e.g., short circuit) nearby when charging the battery. • Be sure to recharge the battery in a well-ventilated and open area. • Note that the charging system for the MF battery is different E from that of a conventional battery. Do not replace the MF L battery with a conventional battery. P CONNECTING THE BATTERY M • When disconnecting terminals from the battery for disassem- A bly or servicing, be sure to disconnect the - battery lead wire, first. S • When connecting the battery lead wires, be sure to connect the + battery lead wire, first. • If the terminal is corroded, remove the battery, pour warm water over it and clean it with a wire brush. • After connecting the battery, apply a light coat of grease to the battery terminals. • Install the cover over the + battery terminal. WIRING PROCEDURE • Properly route the wire harness according to the “WIRING HARENESS ROUTING” section. (10-18 to -20)