ENGINE 3-77 • Set the crankshaft to the conrods and upper crankcase. • Apply a MOLYBDENUM OIL SOLUTION to the crank pin and bearing surface. MOLYBDENUM OIL SOLUTION  Be sure to clean the conrod big end. • When fitting the conrod cap, make sure that I.D. code A on each conrod faces intake side. • Apply engine oil to the bearing cap bolts. E • Tighten the bearing cap bolt by using a 12 mm, 12 point socket wrench in the following two steps. L Conrod bearing cap bolt: P Initial: 37 N·m (3.7 kgf-m, 27.0 lb-ft) Final : 60° (1/6 turn) M • Apply engine oil to the conrod big end side surfaces. A • Check the conrod movement for smooth turning. S 60˚ • Apply a MOLYBDENUM OIL SOLUTION to each crankshaft journal and bearing lightly. MOLYBDENUM OIL SOLUTION